Phottix Raja Quick-Folding Softbox 60x90cm: Setup Guide

By T K FOTO TECHNIC PTE LTD | Published: 2026-11-04

Category: ハウツーガイド

Learn how to set up the Phottix Raja Quick-Folding Softbox 60x90cm in seconds. Step-by-step assembly, baffle and diffuser placement, and safe mounting tips.

Quick answer

Open the Raja like an umbrella, lock the frame, then fit the inner baffle, front diffuser and grid before mounting it on your studio light. The whole sequence takes seconds once you know the order.

Why the 60x90cm rectangular shape changes your setup choices

A rectangular softbox throws a wider pool of light in one direction than a square box of similar depth. That makes it useful for lighting a standing subject or a small group, but it also means the box is longer on one side and needs more clearance around your light stand.

The Raja's quick-folding mechanism is designed to be opened and closed repeatedly, so treat the setup as a repeatable routine rather than a one-time build. Keep the baffle, diffuser and grid together in the same bag so you never hunt for a missing panel mid-shoot.

When to skip the grid or diffuser

The full setup with baffle, diffuser and grid gives the softest, most controlled light. If you need a harder, more directional look or you are working in a tight space, you can leave the grid off, but the front diffuser should normally stay on to protect the inner baffle and spread the light evenly.

If you are shooting at low power or with a speedlight, the double diffusion can eat a stop or more of output. In that case, remove the inner baffle first and keep the front diffuser, rather than removing both.

Step-by-step Raja 60x90cm setup

Open the frame like an umbrella: Hold the speed ring steady and push the umbrella-style hub until the frame clicks into its open position. Do not force it if it resists; check that all ribs are aligned before pushing further. Listen for the click and confirm the frame is fully locked before letting go.
Fit the inner baffle: Attach the inner baffle to the small loops or tabs inside the box, starting at the corners and working toward the middle. A common mistake is leaving one corner unhooked, which creates an uneven hotspot. Run your hand around the perimeter to confirm every attachment point is secured.
Add the front diffuser: Stretch the front diffuser over the open side and secure it at the edges. Pull it taut but not so tight that it distorts the frame; a sagging diffuser softens light unevenly. Check that the diffuser sits flat and does not block the speed ring opening.
Attach the grid if needed: If you are using the grid, fit it over the front diffuser before mounting the box on the light. Trying to add the grid after mounting often means removing the whole box again. Decide on the grid before you lift the box onto the stand.
Mount on your studio light: With the light switched off, fit the speed ring to your strobe or continuous light and tighten the locking mechanism. Support the box with one hand while tightening so the weight does not stress the mount. Give the box a gentle tug to confirm it is seated before turning the light on.
Aim and secure the stand: Angle the box toward your subject and check that the stand is balanced, especially with the longer 60x90cm side extended. Use a sandbag on the stand base if the box is angled downward. Re-check the stand balance after every angle change, not just at setup.

Product facts

Phottix Raja Quick-Folding Softbox 60x90cm: The Phottix Raja series opens like an umbrella and is ready to use in seconds. You can set up and strike the box quickly between shots, which suits changing studio or location schedules.
Phottix Raja Quick-Folding Softbox 60x90cm