How to Use the Sirui Traveler 5CX with B-00K BallHead
By T K FOTO TECHNIC PTE LTD | Published: 2026-10-31
Category: How-to Guides
Learn how to set up and use the Sirui Traveler 5CX tripod with the B-00K ball head for stable, compact travel photography.
Quick answer
Set up the Sirui Traveler 5CX by unlocking the legs, extending each section fully, locking the ring locks, then attaching the B-00K ball head for quick leveling and positioning.
Why the Traveler 5CX works well for travel
The Sirui Traveler 5CX folds down to just 33 cm with the head attached, making it easy to pack in a carry-on bag. Each leg has five sections with four sealed ring locks, so stability is good even with a compact system camera. The included B-00K ball head adds a separate leveling step, which helps when you need to quickly adjust the camera angle without moving the legs.
Limitations to keep in mind
This tripod is designed for compact and system cameras, not heavy full-frame gear with long lenses. The five-section legs require careful lock tightening each time, or the tripod may sag slightly under load. The B-00K ball head has a separate clamp, so you need to ensure it is tightened enough to prevent rotation.
Setting up the Sirui Traveler 5CX with B-00K BallHead
- Unfold the legs and set the height: Rotate the leg lock collar counterclockwise to release each leg. Swivel each leg outward until it clicks into the open position. Extend each leg section one by one, pulling until the ring lock engages. Tighten each ring lock by turning it clockwise until snug. Common mistake: not fully tightening the ring locks, causing the leg to slip. Check each lock by pressing down on the leg—it should not collapse.
- Attach the B-00K ball head: Remove the protective cap from the tripod center column. Screw the B-00K ball head onto the 3/8-inch thread until hand-tight. Do not overtighten. The ball head provides a separate leveling base for adjusting camera angle. If the ball head feels loose after attaching, check that the thread is clean. A small amount of thread lock can help, but avoid using tools.
- Level the camera platform: Place your camera on the ball head's quick-release plate. Loosen the ball head's locking knob slightly, then tilt the camera to level the bubble indicator. Tighten the locking knob to secure the angle. For precise leveling, use the built-in bubble level on the ball head. Common mistake: tightening the ball head knob before leveling, which locks the angle and prevents adjustment. Always loosen first, then level, then tighten.
- Final stability check: Gently press down on the camera to ensure the tripod does not wobble. Check that all four ring locks are still tight. If the tripod feels unstable, re-extend each leg section and retighten the locks. If you are on uneven ground, adjust the leg length individually to level the tripod base before attaching the ball head.
Product facts
- Sirui Traveler 5CX w/B-00K BallHead: The legs can be swivelled upwards by 180°, so that the tripod is just 33 cm high when folded (with head). Each leg consists of 5 sections with 4 sealed ring locks. This compact folded size fits in most bags, but you must fully extend and lock each section to avoid instability.
Sirui Traveler 5CX w/B-00K BallHead
