How to Attach and Use the MagMod MagSnoot for Light Control
By T K FOTO TECHNIC PTE LTD | Published: 2026-10-26
Category: How-to Guides
Learn how to quickly attach the MagMod MagSnoot to your flash using the MagGrip, adjust its four beam patterns, and avoid common mistakes for precise light shaping.
Quick answer
Attach the MagMod MagSnoot to your speedlight via the MagGrip, then collapse the snoot to one of four positions to control the beam width. Each stage gives a distinct pattern, from a wide spot to a tight pencil beam.
Why the MagSnoot works differently from traditional snoots
Most snoots are rigid tubes or cones that give you one beam width. The MagSnoot uses a single molded rubber piece that folds into four stages, so you can switch between patterns without swapping modifiers. That makes it especially useful when you need to adjust light spread quickly on location.
The trade-off is that the beam edges are softer than a metal snoot, and you cannot flag light as tightly as a grid. For portraiture or product accents where a clean, hard edge is unnecessary, the convenience outweighs the slight loss of sharpness.
What you need before you start
The MagSnoot does not attach directly to a flash. It requires the MagGrip (sold separately), which magnetically holds the modifier in place. Make sure your speedlight has a compatible MagGrip installed before you attempt to use the snoot.
How to attach and use the MagMod MagSnoot
- 1. Install the MagGrip on your flash: Slide the MagGrip over the head of your speedlight until it clicks or snaps into place. Ensure the metal ring is fully seated so the magnet holds securely. Common mistake: attaching the grip crookedly leads to weak magnetic hold – check that the grip is centered on the flash head.
- 2. Attach the MagSnoot to the MagGrip: Hold the MagSnoot near the MagGrip’s metal ring – the magnet will pull it into position. Center the snoot over the flash lens for even light distribution. Common mistake: letting the snoot snap on off-center can cause uneven falloff. Gently guide it until you feel the magnet align flat.
- 3. Choose your beam pattern by collapsing the snoot: The MagSnoot has four preset stages. Push the front of the snoot inward to shorten it – each stage produces a different beam width. Stage 1 gives the widest spot; Stage 4 gives the tightest pencil beam. Test each stage with a test shot before your subject arrives. The difference between stages can be subtle depending on your flash-to-subject distance.
- 4. Adjust the angle of the snoot: Because the MagSnoot is held by a magnet, you can tilt or rotate it slightly by hand to feather the light or aim the beam precisely. The magnetic hold is strong enough to stay put once positioned. Common mistake: assuming the snoot is locked in place. It can shift if bumped, so check the position between shots.
- 5. Remove the MagSnoot when done: Pull the snoot straight off the MagGrip. The rubber is flexible, so you can also collapse it fully for storage. Wipe it clean with a dry cloth if needed. Do not yank at an angle – that can stress the rubber or pop the MagGrip off the flash.
Product facts
- MagMod MagSnoot: The MagSnoot collapses into four stages to give four unique beam patterns, and is made from a single molded rubber construction that is compact, flexible, and durable. You can adjust beam width on the fly without carrying extra modifiers, and the rubber build survives drops and constant folding without cracking.
MagMod MagSnoot
